[odb-users] libodb-qt error... QtCore not found...

[Javier Estalis]

well Boris Kolpackov, i found this...

/home/leoxnidas/Qt/5.5/gcc/include/QtCore/qglobal.h:1067:4: error: #error
"You must build your code with position independent code if Qt was built
with -reduce-relocations. " "Compile your code with -fPIC (-fPIE is not
enough)."
 #  error "You must build your code with position independent code if Qt
was built with -reduce-relocations. "\

but i am not sure how to use -fPIC;  this is my input ...

./configure --with-pic=PIC CPPFLAGS=-I/home/leoxnidas/Qt/5.5/gcc/include
LDFLAGS=-L/home/leoxnidas/qt/5.5/gcc/lib --prefix=/home/leoxnidas/Qt/5.5/gcc

2015-10-14 8:59 GMT-04:30 Boris Kolpackov <boris at codesynthesis.com>:

> HI Javier,
>
> Javier Estalis <leo.leoxnidas.c.14 at gmail.com> writes:
>
> > when i use ./configure CPPFLAGS=-I/home/leoxnidas/Qt/5.5/gcc/include
> > LDFLAGS=-L/home/leoxnidas/qt/5.5/gcc/lib --prefix
> /home/leoxnidas/Qt/5.5/gcc
> >
> > this is the output
> >
> > configure: error: QtCore is not found; consider using CPPFLAGS/LDFLAGS to
> > specify its location...
>
> When you get an error from a configure-based build system, the first
> place you should look is config.log. It can contain quite a bit of
> stuff, so it makes sense to use search to quickly get to what you are
> interested in. In this case, 'QtCore' would be a good search term. Also
> note that there could be multiple tests with some of them failing. So
> don't just stop at the first error and assume this is the cause. Check
> further down until you see where the test gives up (i.e., prints the
> above error, in your case).
>
> Having said all this, I am pretty sure the cause of this is the lack
> of the -fPIC option which Qt5, bizarrely, requires all client code
> to be built with.
>
> Boris
>