[odb-users] Cannot use odb because of GCC error
Патрушев Данил Андреевич
d.patrushev at prosoftsystems.ru
Thu Jun 13 05:41:09 EDT 2019
Thanks for the help. I successfully built build2 from stage. As for the ODB compiler, I rashly followed the usual install instructions by typing "bpkg build odb at https://pkg.cppget.org/1/beta" (not the stage repo) , but was
nevertheless able to successfully build it and later use it to build our project). Is it critical that I use the odb compiler version at stage.build2.org?
С уважением,
Инженер-программист
ООО «Прософт-Системы»
Патрушев Данил Андреевич
________________________________________
От: Boris Kolpackov <boris at codesynthesis.com>
Отправлено: 13 июня 2019 г. 14:08
Кому: Патрушев Данил Андреевич
Копия: odb-users at codesynthesis.com
Тема: Re: [odb-users] Cannot use odb because of GCC error
Boris Kolpackov <boris at codesynthesis.com> writes:
> After the upcoming 0.11.0 release of build2 (tomorrow, if all goes
> well), we will upgrade the next development series to GCC 9.1 at
> which point you can try build2 and ODB from stage [...]
GCC 9.1 is now available on stage. Can you try to get both build2
and ODB from:
https://build2.org/community.xhtml#stage
It's the same ODB installation instructions[1] but using the
stage.build2.org repository instead of cppget.org. Just make
sure you get build2 install scripts for stage.
[1] https://codesynthesis.com/products/odb/doc/install-build2.xhtml
More information about the odb-users
mailing list